Value Range0–240 sFeature Guide References2.14.2 ConferenceMiscellaneousCaller ID—Waiting to receive (s)Specifies the length of time that the PBX waits to receive Caller ID from an analogue trunk. If the Caller ID isreceived through an analogue trunk card on which no Caller ID card is mounted or through a port to whichCaller ID Detection is disabled, this timer is not applicable.Value Range0–15 sPC Programming Manual References11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification14.1 PBX Configuration—[6-1] Feature—System Speed DialFeature Guide References2.19.1 Caller IDCaller ID—Visual Caller ID Display (s)Specifies the length of time that a Caller ID number, with the Call Waiting tone offered by an analogue linefrom the telephone company, is shown on the display. The Caller ID number flashes on the display for fiveseconds, followed by a 10-second pause, then flashes again for five seconds.Value Range0–250 sFeature Guide References2.1.3.3 Call Waiting2.10.4.2 Call Waiting Tone2.19.1 Caller IDExtension PIN—Lock CounterSpecifies the number of successive incorrect PIN entries allowed before the extension PIN is locked. A lockedextension PIN cannot be used until reset from the extension assigned as manager. (Specifying "None" disablesthis counter.)Value RangeNone, 1–15406 PC Programming Manual10.3 PBX Configuration—[2-3] System—Timers & Counters
