6.14 Tool—UT Option SettingOption settings can be specified for KX-UT series SIP phones on a system-wide level.NoteThe following apply when programming in On-line mode only:• To set these parameters, all installed V-UTEXT cards must first be set to OUS. For details, see 9.1 PBXConfiguration—[1-1] Configuration—Slot.Numbering Plan for UT Series TerminalOne or more number dialling plans can be specified for KX-UT series SIP phones. Enter the dial plan text stringinto the text box, and then click OK. A dial plan text string may also be copied and pasted into the text boxfrom another source.Note• For more information about dial plans, refer to the Administrator Guide of the relevant KX-UT seriesSIP phone.• You can enter up to 500 characters in the dial plan text box.• You can assign up to 20 dial plans, separating them with a "|" (vertical bar).• You can assign up to 32 digits per dial plan.• When OK is clicked, the entered text string will be validated. If there is a validation error, a messagewill be displayed.Timer for UT Series TerminalThis timer specifies for KX-UT series SIP phones how long the system waits for another digit to be dialledbefore determining that dialling has finished. This value will apply for all KX-UT series SIP phones connectedto the PBX. Specify a number of seconds in Extension Inter-digit (s), and then click OK.If the value for the timer is changed, the new value will be applied to each KX-UT series SIP phone after it isrestarted.PC Programming Manual 996.14 Tool—UT Option Setting
