10.4 PBX Configuration—[2-4] System—Week TableA specific time mode (day, night, lunch, or break) can be selected for operation depending on the time of day.The time mode can be switched either automatically or manually. Select the desired switching mode from theTime Service Switching Mode option.Time Table numbers correspond to tenant numbers (for example, Tenant 1 uses Time Table 1). Select thedesired Time Table from the Time Table No. list.When in Automatic Switching mode, the time modes of the tenant are switched as programmed in thecorresponding Time Table. Manual switching is possible only from an authorised extension (determined byCOS).• To adjust the currently displayed Time Table, click and drag the divisions between two time periods.• To programme the time blocks of the currently displayed Time Table, including adding or deleting timeblocks, click Time Setting.10.4.1 PBX Configuration—[2-4] System—Week Table—TimeSettingThe start times of 4 different time blocks can be programmed for each day of the week, for the selected TimeTable, as well as the start and end times of up to 3 break periods.1. Day/Lunch/Night—Day1 Start, Lunch Start, Day2 Start, Night Start—SettingEnables the setting of the start time for each time block.Value RangeDisable, EnableFeature Guide References5.1.3 Tenant Service5.1.4 Time Service1. Day/Lunch/Night—Day1 Start, Lunch Start, Day2 Start, Night Start—Hour,MinuteSpecifies the start time for each time block. Times can only be set when 1. Day/Lunch/Night—Day1 Start,Lunch Start, Day2 Start, Night Start—Setting is set to Enable.Value Range00:00–23:59Feature Guide References5.1.3 Tenant Service5.1.4 Time Service2. Break—Break 1–3 Start—SettingEnables the setting of the start time for each break period.PC Programming Manual 41110.4.1 PBX Configuration—[2-4] System—Week Table—Time Setting