4–Non-Interactive CommandsCommand SummarySN0054614-00 K4-15In the previous commands, the variables indicate the following (see alsoTable 4-4:Firmware Update CommandsTo update the firmware on the FCoE, issue the following command:#scli -fcoe(<hbainstance>|<hbawwpn>)--loadfwfile>hba instance= Adapter instance number (use-gcommand to find)hba wwpn= World wide port name of the adapterparam name= Name of the parameterparam alias= Alias of the parameterparam value= New value of the parameter-port0= FCoE access port 0-port1= FCoE access port 1Table 4-4. FCoE Engine ParametersParameter NameAliasValueDescriptionPortTypeAT0, 10=Access (default)1=TrunkPauseTypePT1, 21=Standard Pause (default)2=Priority Flow ControlPriorityPause-MaskPM0, 1, ..7Specifies the bit location of the pause maskto be set to 1; that is, a PriorityPauseMasktype of 1,3,4 means that bit 1,3,4 is 1, therest are zeros. This equals 1a (hexadeci-mal) or 26 (decimal). This mask is valid onlyif the PauseType is set to Priority Flow Con-trol.FCoEConfigFC0, 10=Pre-T11 Frame Format1=T11 Rev 0 Frame Format (If supported)COSCS0–7By default, the default value for priorityencoded FCoE packet is 3. This settings isper Fibre Channel port.
