4–Non-Interactive CommandsCommand Summary4-44 SN0054614-00 KYou can specify the QoS of the virtual port based on either priority,bandwidth speed, or bandwidth percentage, where:You can change the lock and enable properties of the virtual port using thefollowing options:-r(Update HBA Parameters)To update the adapter parameters, type the following:# scli -r (<hba instance> | <hba wwpn> | all) <File Name>Where:To save the adapter parameters to a file, type:# scli -r (<hba instance> | <hba wwpn>) save <File Name>Where:--pri = Priority to assign to the virtual portpriority = Priority value: low, medium, or high--bwspd = Bandwidth speed to assign to the virtual portspeed = Value of bandwidth speed--bwper = Bandwidth percentage to assign to the virtual portpercent = Value of bandwidth percent--lock = Specify the lock valuelock value = Lock value: 1 for lock or 0 for unlock.--enable = Specify whether the virtual port is enabledenable value = Enable value: 1 for enable or 0 for disablehba instance = Adapter number (use -g command to find)hba wwpn = World wide port name of the adapterall = All adapter ports in the system are updated with the newadapter parametershba parameters filename= File name or a path to a file that contains the updated adapterparametershba instance = Adapter number (use -g command to find)hba wwpn = World wide port name of the adapterhba parameters filename= File name or a path to a file to save the adapter parameters
