© Copyright Qvis® All documentation rights reserved. 1072) The proxy server software developed from the SDK. Please open the software and input theglobal setup. Please make sure the auto connection port here is the same as the port you set inthe previous step.3) Now you can add device. Please do not input default port number such as the TCP port in themapping port number. The device ID here shall be the same with the ID you input in Figure 5-38.Click Add button to complete the setup.4) Now you can boot up the proxy server. When you see the network status is Y, it means yourregistration is OK. You can view the proxy server when the device is online.Important: The server IP address can also be the domain. But you need to register adomain name before you run proxy device server.5.3.6 AlarmPlease refer to chapter 4.7 Alarm Setup and Activation.5.3.7 DetectPlease refer to chapter 4.6 Detect.5.3.8 Pan/Tilt/ZoomThe pan/tilt/zoom setup includes the following items. Please select channel first. See Figure 5-39. Protocol: Select corresponding PTZ protocol such as PELCO-D. Address: input corresponding PTZ address. Baud rate: Select baud rate. Data bit: Select data bit. Stop bit: Select stop bit. Parity: There are three choices: none/odd/even.After completed all the setups please click save button, system goes back to the previous menu.For detailed setup, please refer to chapter 4.10 preset/patrol/pattern/scan.
