Qvis IAPOLLO HDRT HD User Manual

Contents

Qvis IAPOLLO HDRT HD User Manual Manual pdf 185 page image

© Copyright Qvis® All documentation rights reserved. 176Please refer to the following sheet for detailed information:Parameter FunctionEventTypeThe abnormal events include: No disk, disk error, disk no space, netdisconnection, IP conflict and MAC conflict.You can set one or more items here.Less than: You can set the minimum percentage value here (For disknot space only). The device can alarm when capacity is not sufficient.You need to draw a circle to enable this function.Enable Check the box here to enable selected function.Alarm Out Please select corresponding alarm output channel when an alarmoccurs. You need to check the box to enable this function.Latch The alarm output can delay for the specified time after an alarm stops.The value ranges from 1s to 300s.ShowmessageSystem can pop up a message to alarm you in the local host screen ifyou enabled this function.AlarmuploadSystem can upload the alarm signal to the centre (Including alarmcentre.SendEmailIf you enabled this function, System can send out an email to alert youwhen an alarm occurs.Buzzer Check the box here to enable this function. The buzzer beeps when analarm occurs.7.8.4 StorageScheduleIn this interfaces, you can add or remove the schedule record setup. See Figure 7-55.There are three record modes: general (auto), motion detect and alarm. There are six periods inone day. Please make sure you have enabled the corresponding record mode in the Setup->Storage->Conditions.You can view the current time period setup from the color bar. Green color stands for the general record/snapshot. Yellow color stands for the motion detect record/snapshot.. Red color stands for the alarm record/snapshot.