© Copyright Qvis® All documentation rights reserved. 754.8.2 PTZ SetupNote: The camera video should be in the current screen. Before setup, please check thefollowing connections are right: PTZ and decoder connection is right. Decoder address setup is right. Decoder A (B) line connects with DVR A (B) line.Boot up the DVR, input user name and password.In the main menu, click setting, and then click Pan/Tilt Control button. The interface is shownas in Figure 4-40. Here you can set the following items: Channel: select the current camera channel. Protocol: select corresponding PTZ protocol(such as PELCO-D) Address: default address is 1. Baud rate: select corresponding baud rate. Default value is 9600. Data bits: select corresponding data bits. Default value is 8. Stop bits: select corresponding stop bits. Default value is 1. Parity: there are three options: odd/even/none. Default setup is none.Figure 4-40After completing all the setting please click save button. Right click mouse (click “Fn” Buttonin the front panel or click “Fn” key in the remote control). The interface is shown as in Figure4-41.
