Copying_ 57- Uncollated: Printouts sorted into stacks of individual pages.• Offset: Printouts are stacked in sets by laying printouts side-to-side.This feature is available only when the standard or booklet finisheris installed.- Off: Disables this feature.- On: This feature can be used.• Rotate: Printouts are stacked criss-crossed in sets.• This feature is available only when the standard or bookletfinisher is not installed.• This feature is available only with Letter- and A4-sized printmedia.• Before using this feature, you have to load the paper in thetrays with SEF (Short edge feed) and LEF (Long edge feed).For example, direction of paper feeding in tray 1 is SEF, anddirection of paper feeding in tray 2 is LEF.- Off: Disables this feature.- On: This feature can be used.• Output Tray: Select the output tray.In CLX-9252 9352 Series, the right tray (face-up) is optionaldevice.In SCX-8230 8240 Series, the Inner Tray (optional Job Separator)is optional device.- Right Tray: If you need to print thick paper or if the paperrepetitively jams in the exit area of the center tray, use the right tray.When you use the Duplex feature (see "Copying multiplesides" on page 55) with the Right Tray as an output tray, itcould slow down the printing speed. We recommend you touse other trays for an output tray.- Inner Tray: The inner tray is efficient for separating the printouts.For example, if you want to avoid received faxes mixing with copy orprint outputs, you can use this inner tray to separate the receivedfaxes.- Center Tray: The machine sends output to the center tray bydefault.When the optional standard finisher or booklet finisher is installed, youcan use more output trays.• Top Tray: Paper sizes not supported by the finishing trayautomatically gets printed out in the top tray.• Finishing Tray: When the optional standard finisher or bookletfinisher is installed, the machine sends output to the finishing trayby default.• Staple: You can staple printouts and adjust the stapling position.• The Staple feature is available only when the standard orbooklet finisher is installed.• When you use the Staple feature, only the finishing tray isavailable for printouts.• When the printout is only one page, the Staple feature doesnot work.• When you have set the the Punch options before setting theStaple options, some options are not available depending onthe staple position and the direction of paper feeding in thetrays.• When printing multiple copies of a job using the Staple feature,it is recommend to monitor the finishing tray. Printouts canbecome crooked and fall off of the finishing tray.- Off: Disables this feature.- 1 Staple: Select this setting to bind the printouts with a staple. Youcan also select the staple positon with Left or Right in StapleDirection.- 2 Staple: Select this setting to bind the printouts with two staples.You can also select the staples positon in Staple Direction.Depending on the options you select the result will vary. Refer to thebelow table before using the 2 Staple option.
