Copying_ 70Cover copyingThe machine automatically adds covers to your copied set using stock takenfrom a different tray. Covers must be the same size and orientation as themain body of the job.You cannot use this feature while using Booklet (see "Bookletcopying" on page 68).1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).3. Select the tray, other than Auto, that has the cover paper loaded in theBasic tab.• If you select Auto, the Covers feature remains inactive.• You have to select a tray that has paper of the same size andorientation as the originals.4. Adjust the settings for each copy such as Reduce/Enlarge, Duplex andmore in the Basic tab (see "Changing the settings for each copy" onpage 54).5. Press the Advanced tab > Covers from the display screen.6. Press the appropriate option.• Off: Disables this feature.• Front: Prints the document with the front cover.• Back: Prints the document with the back cover.• Front & Back: Prints the document with the front and back cover.7. Press 1 Sided Printed Sheet in Cover Sheet to select if the cover willbe 1-sided, 2-sided, or blank paper.8. Select a tray in Paper Source.9. Press OK from the display screen.10. Press Start on the control panel to begin copying.Transparency copyingThis feature prevents copies to print onto transparencies from stickingtogether as a cause by heat that is produced during copying. You can alsocopy originals to the separator sheets.1. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).2. Load the right-sized transparencies with the side to be printed facingdown on the multi-purpose tray.3. Press Machine Setup > Tray Settings > Settings > MP Tray > Papertype > Transparency > OK from the display screen.4. Press ( ) and Copy from the display screen.5. Press the Advanced tab > Transparency from the display screen.6. Press the appropriate option.• No Transparency: Does not place separator sheets betweentransparencies.• Blank Separators: Places a blank sheet between transparencies.Select a tray which loaded paper for separating from Separator.• Printed Separator: Places the same image on the separator sheetsas printed on the transparency. Select a tray which loaded paper forseparating from Separator.7. Press OK from the display screen.If you did not select Transparency in step 3, a pop-up windowappears.8. Press Start on the control panel to begin copying.
