Samsung OfficeServ ITP-5121D User Manual

Also see for OFFICESERV 500 Series: Service manual System administration guide Quick setup guide Quick setup guide Quick setup guide

Contents

System Server SetupFrom the Main Setup Menu, the fifth item [5. SYSTEM SERVER SET UP] sets ormodifies settings related to registering the phone to the MCP. You can obtain thisinformation from your system administrator. The screen below is displayed.You can set/modify the IP address of the MCP at the [1. SERVER IP ADDRESS] item.The screen below is displayed when you enter the item. The server IP is the IPaddress of the MCP2/MCP.You can confirm the current IP address of the MCP at the LCD panel. The addressis left blank if it is not set. Use the dial buttons from [0]-[9], and [] to set the IPaddress and press the SPEAKER button to save and exit. Select the [2. SERVERID] menu. Use the HOLD button to backspace.You must input the ID assigned to your ITP phone. See your phone system admin-istrator to get this value. Press the SPEAKER button to save and exit. Select the [3.SERVER PASS] item.You must input the password associated with your ID. See your phone systemadministrator to get this value. Press HOLD to backspace. Press the SPEAKER but-ton to save and exit.Completion of SettingsFrom the main menu, select the seventh item [7. REBOOT] to save all modifiedsettings and reboot the ITP-5107S phone.13• Select the [3. NETMASK SET UP] menuand press SPEAKER, the LCD will displaythe following message and the user canenter a new Netmask IP address. Use theHOLD button to backspace.Check if there is any currently saved subnet mask address of the phone on theLCD. If the subnet mask address has not been set, the display will show nothing.Press any dial buttons from [0]-[9] and [] button to enter the subnet mask IPaddress and then save that subnet mask IP address by pressing the SPEAKER but-ton. Use the HOLD button to backspace.• Select [4. GATEWAY SET UP] menu andpress SPEAKER, the LCD will display thefollowing message and the user canenter a new gateway address.Check if there is any currently saved Gateway IP address of the phone on the LCD.If the gateway IP address has not been set, the LCD displays nothing.The user canenter the gateway IP address by using [0]-[9] and [] button and can save that IPaddress by pressing the SPEAKER button. Use the HOLD button to backspace.NOTE: In the [3. NETWORK SET UP MENU], [1. NETWORK MODE SETUP] option,when [2. DHCP] is selected the IP address, Netmask, and Gateway will not be dis-played on the LCD. Press HOLD to exit to Main Menu.Load and Upgrade Set/ModifyThe fourth item [4. LOAD & UPGRADE SET UP] sets or modifies the IP phone’ssoftware version. Use extreme caution when upgrading the keyset. Only use thisif you are upgrading your IP keyset firmware.Select the [4. LOAD & UPGRADE SET UP] item and move to the lower level. Thescreen below is displayed.Select option [1. UPGRADE TFTP SERVER] and enter the IP address of the TFTPserver containing the ITP software. Use [0]-[9] and [] button to enter the IPaddress. Press SPEAKER to save.Select option [2. UPGRADE START] and press SPEAKER to start the upgradeprocess. Press HOLD to exit.INPUT NETMASK & PRESS OKxxx.xxx.xxx.xxxINPUT GATEWAY & PRESS OKxxx.xxx.xxx.xxx121.UPGRADE TFTP SERVER2.UPGRADE START1.SERVER IP ADDRESSINPUT SERVER IP ADDRESSxxx.xxx.xxx.xxxINPUT SYSTEM IDINPUT SYSTEM PASSWORD