Duplication Commands (Create)167Valid Ranges:1 - 5461 lines for 6 LPI1-7281 lines for 8 LPINOTE: Make sure to send the proper command for the LPI. If you send theLFORMS command when the printer is set for 6 LPI, the results arenot desirable.Duplication Commands (Create)There are two commands that can be used to duplicate elements on a form:HDUP (Horizontal Duplication) and VDUP (Vertical Duplication). Eachspecifies the number of times the element will be printed and the spacingbetween each duplication. These commands function with any element on aform except Overlay Data.Horizontal Duplication CommandThis command allows you to duplicate specific elements horizontally on aform, such as lines, logos, barcodes, etc. The basic command is:Table 12. Horizontal Duplication CommandField Function Option/Modifier SelectionsHDUP; Command Specifier Enter HDUP;dups; Specifies number of duplications. Enter the desired number of duplications.The valid range of values is 1-255. Makesure there is enough room on the form forthe duplication(s) to print.dist Specifies the distance from thestarting point of one element to thenext duplication. This parametermay specify columns or dots or acombination of columns and dotpositions.Enter a column or dot distance or acombination of columns and dots.Whether in columns or dots depends onthe SCALE Command. You may also usethe XX.YY format for plotting duplicationprint locations explained earlier in theStandards Section.element Defines the element that will beduplicated.You may define a line, call a logo ora barcode, etc.Enter print information in proper format.
