Box Command (Create)177Box Command (Create)This command is used to construct boxes at different locations on the form.The basic command for creating a box is:Line Feed A Line Feed command mustseparate the Execute Sequencefrom the NORMAL command.Enter Line Feed CommandNORMAL Initiates printing of last form andreturns printer to NORMAL Mode.Enter the current Special Function ControlCharacter followed by NORMAL.NOTE: Do not forget to include a LineFeed before this command.Table 17. EXECUTE Form Command Optional ParametersField Function Option/Modifier SelectionsTable 18. Box CommandField Function Option/Modifier SelectionsBOX This is the command specifier.Using the following parameterscreates a box that expands downand to the right from the startingpoint at a specific line thickness.Enter BOXLT; Dictates the line thickness. Line thickness is based on dot increments(1/72”) horizontally and vertically. Linethickness is only limited by yourspecifications. Do not forget the parameterdelimiter.The SR, SC, ER, and EC parameters use the same methods for defining the BOX Print area.Whether in columns or dots depends on the SCALE Command. You may also use the XX.YYformat for plotting duplication print locations explained earlier in the Standards Section.SR; Plots the starting ROW of the box. Enter a value ranging from 1 to one lessthan the maximum form length and theparameter delimiter.SC; Plots the starting COLUMN of thebox.Enter a value ranging from 1 to one lessthan the maximum form width and theparameter delimiter.
