194Chapter 9 PGL CommandsHorizontal And Vertical Line Commands (Create)In addition to boxes and corners, you can print horizontal and vertical lines onyour forms. The following commands control location, length, and thickness ofhorizontal and vertical lines.Horizontal Line CommandTable 29. Horizontal Line CommandField Function Option/Modifier SelectionsHORZ This is the command specifier. Thefollowing parameters define printlocation and line thickness of ahorizontal line.Enter HORZLT; Dictates the line thickness. Horizontal line thickness is based on dotincrements (1/72”). Line thickness is onlylimited by your specifications.HE Horizontal expansion amount. Enter a value specifying the desiredexpansion factor, then end the entry withthe parameter delimiter. Valid selectionsrange from 0-113. A selection of 0 returnsyou to standard size characters.The SR, SC, and EC parameters control placement, length, and thickness of horizontal lines on aform. Whether in columns or dots depends on the SCALE Command. You may also use theXX.YY format for plotting duplication print locations explained earlier in the Standards Section.SR; Plots the starting ROW of the line. Enter a value ranging from 1 to one lessthan the maximum form length and theparameter delimiter.SC; Plots the starting COLUMN of theline.Enter a value ranging from 1 to one lessthan the maximum form width and theparameter delimiter.EC Plots the ending COLUMN of theline.Enter a value ranging from 2 to one lessthan the maximum form width.
