Create Logo Command (Normal)187Using The Create Form CommandThis example shows how to design an employment application form for anExplosives Handler for a Demolition Company. To enter CREATE Mode anddesign a form called JobAppl, send the following command to your printer:CREATE;JobApplTo enter CREATE Mode and design the same form, send the followingcommand to your printer:CREATE;JobApplTo enter CREATE Mode and assign a Form Length of 10 inches, send thefollowing command to your printer:CREATE;JobAppl;720After entering CREATE Form Mode send the required commands to completethe form.Now that you have informed the printer that you wish to CREATE a formcalled JobAppl that is 10 inches long, you can finish creating your form usingthe appropriate commands in the CREATE Form Mode.Create Logo Command (Normal)This command allows you to create logos for your forms. It initiates the LogoCREATE Mode, which enables you to create and store logos that will becalled in CREATE Mode for use in creating forms. Logos are defined usingspecific dot placement within a grid.This command names the logo then specifies a grid size for the logo andwhich dot positions within the grid will be printed. The grid is 72 DPI verticallyand 60 DPI horizontally. The maximum size of the grid is 252 dot rows (3.5inches) by 240 dot columns (4 inches). When defining the grid, it is best not toexceed the actual requirements needed to produce the logo. For example, ifyour logo is going to be 1 inch high by 1.5 inches tall, the grid would be thesame size in dots (72 by 90). The basic command for creating a logo is:
