Create Corner Frames (Create)183Create Corner Frames (Create)This command allows you to crate Corner Frames for your forms. Similar tothe BOX command, you define starting and ending points but in addition, youspecify the length of the horizontal and vertical arms of each corner frame.The basic command for creating Corner Frames is:Table 22. Corner CommandField Function Option/Modifier SelectionsCORNER This is the command specifier.Using the following parameterscreates a set of corners around aspecified area of the form at aspecific line thickness and length ofvertical and horizontal arms ofeach corner.Enter CORNERLT; Dictates the line thickness. Line thickness is based on dot increments(1/72”) horizontally and vertically. Linethickness is only limited by yourspecifications. Do not forget the parameterdelimiter.The SR, SC, ER, and EC parameters use the same methods for defining the CORNER Print area.Whether in columns or dots depends on the SCALE Command. You may also use the XX.YYformat for plotting duplication print locations explained earlier in the Standards Section.SR; Plots the starting ROW of thecorner.Enter a value ranging from 1 to one lessthan the maximum form length and theparameter delimiter.SC; Plots the starting COLUMN of thecorner.Enter a value ranging from 1 to one lessthan the maximum form width and theparameter delimiter.ER; Plots the ending ROW of thecorner.Enter a range ranging from 2 to one lessthan the maximum form length and theparameter delimiter.EC Plots the ending COLUMN of thecorner.Enter a value ranging from 2 to one lessthan the maximum form width.The VL and HL parameters specify the arm length of each corner piece in dots or charactersdepending on the SCALE Command. You may also use the XX.YY format.
