186Chapter 9 PGL CommandsCreate Form Command (Normal)This command is used to enter CREATE Form Mode. The command structurefor entering CREATE Mode is:Table 23. Enter CREATE Mode CommandField Function Option/Modifier SelectionsCREATE Indicates CREATE Mode. Enter the current Special Function ControlCharacter followed by CREATE.;Name Enter the name of the form in thisfield.Form names are allowed a maximum ofeight characters. The follownig ASCIIcharacters may be used in form names:• Upper and lower-case A - Z(HEX 41 - 5A and 61 - 7A)• Number 0 - 9 (HEX 30 - 39)• Dollar sign $ (HEX 24)• Percent Sign % (HEX 25)• Dash - (HEX 2D)• At sign @ (HEX 40)• Braces { } (HEX 7B and 7D)• Parens ( ) (HEX 28 and 29)• Tilde ~ (HEX 7E)• Single quotes ‘ ‘ (Hex 60 and 27)• Exclamation point ! (HEX 21)• Pound sign # (HEX 23)• Amersand & (HEX 26);FLForm LengthThis parameter sets the FormLength in three ways:• Automatic form length• Specific form length in dotrows.• Default form length in dot rows(Also see LFORM 6 and LFORM 8Commands)Enter 0 to set the Form Length to endautomatically after the longest element.Enter a value from 1 - 65,535 dot rows toset the Form Length to a specified amount.To compute the desired number of dotrows multiply length in inches by 72. To setform length to the default (792 dot rows)do not enter a value in this field.
