7.5 CPI37• Second Graphics Pass - ^M0303040^KH^KFOPTION^KF^KH^-^KH Toggles Half-Tone Mode ON and defaults to lastpattern selected (EA).^KF Toggles ON Half-Dot Mode.OPTION Data printed with the selected pattern (EA) in Half-Tone/Half-Dot Mode.^KF Toggles OFF Half-Dot Mode.^KH Toggles OFF Half-Tone Mode.Block Character FontsBlock character fonts are created from the block character set in four graphicorientations, and are available in the following sizes:• 7.5 CPI block characters, 0.2 inches high.• 10 CPI block characters, 0.1 inch high.• 12 CPI block characters, 0.1 inch high.• 15 CPI block characters, 0.1 inch high.7.5 CPIThe 7.5 CPI character set is 2/10 inches high and 0.15 inches wide (0.51 cmhigh by 0.38 cm wide). All characters in this set are printed in upper case,even if the characters received from the host are lower case.Command ^{M,U,V,E}0000jjD^-Arguments^{M,U,V,E} One of four Graphics Pass orientations (^M forhorizontal, ^V for clockwise rotation, ^E forcounterclockwise rotation, or ^U for upside downand reverse order of characters.)0000 A height/width value of 0000 specifies 7.5 cpicharacters.jjd Justification values in increments of 0.1 inches(0.25 cm) and dot rows as discussed in theGraphics Pass Command description below. Thisfield may be omitted entirely if the justification valueis zero. The characters to be printed.Example: The Graphics Pass ^M00000007.5 CPI CHARACTERS^- prints:
