55-14 Setting up the Fiery EX2101 from a Windows ComputerTo set the subnet mask, enter one of the following values:• 255.0.0.0 if the IP address starts with a number less than 128• 255.255.0.0 if the IP address starts with a number from 128 through 191• 255.255.255.0 if the IP address starts with a number greater than 191N OTE : Confirm the subnet mask setting with your network administrator beforeproceeding. In some cases, the required setting may be different from those listed.If your TCP/IP network has a gateway and users outside the gateway plan to print tothe Fiery EX2101 using TCP/IP, enter the gateway address.N OTE : The Fiery EX2101 stores assigned IP addresses, even if you later disable TCP/IP.If you need to assign the Fiery EX2101 IP address to another device, first set theFiery EX2101 address to a null address.ServicesYou can configure the following network services:LPD Printing (TCP/IP)/Enable LPD Printing Service—enable or disable LPDprint services.NetWare Printing (PServer)/NetWare Services—specify NDS and Bindery services(see page 5-15).Windows Print Sharing (SMB)/Windows Printing Service—enable or disable SMBprint services.SNMP Setup—enable or disable SNMP services (Local Setup only)HTTP Support (WWW)/Enable Web Services—enable or disable support for FieryWebTools and IPP printing.Port 9100 (TCP/IP)/Enable Port 9100—enable or disable support for Port 9100printing.Email Setup/E-mail Service—specify the Fiery E-mail Service.
