22-10 Setting up Network ServersYou do not need to rerun Setup when you add or remove a NetWare queue; however,you should restart the Fiery EX2101 after you create or remove a queue.When the Fiery EX2101 is configured to connect to a NetWare server, it polls theNetWare server for jobs in each of its queues. If jobs are found, they are automaticallytransferred over the network to the matching connection on the Fiery EX2101.For example, jobs from the NetWare queue with the _print extension are sent to theFiery EX2101 Print queue. While a job is processed and printed, a record of the job isbeing created. You can access the Job Log containing these records at any time.Configuring a NetWare server for printingThe following sections explain how to set up a NetWare file server so networked userscan print to the Fiery EX2101 from their workstations, and the Fiery EX2101 canobtain print jobs from the NetWare server.For each NetWare file server that you configure, follow these general steps. More detailis provided in subsequent sections and in your NetWare documentation.• Make sure the server is connected to a functioning IPX network.• Log in as the Supervisor on a PC connected to the NetWare file server.• For NetWare installations, set up an NDS connection (see “Setting up an NDSconnection” on page 2-12).• For NetWare in emulation mode, set the bindery context (see “Setting the NetWarebindery context” on page 2-12).• For NetWare in bindery emulation, set up a file server, print server, and Print queuefor the Fiery EX2101 (see “Setting up a NetWare Print queue for bindery” onpage 2-13).
