PRINT FORMAT COMMANDS6-28 XEROX DOCUPRINT 180 LPS PDL REFERENCEPoints to noteNote the following when using the EXPORT command:• SNUMBERIf you specify a line and column value for SNUMBER that is offthe page, the segment number will not print. Furthermore, if thesystem encounters a valid SNUMBER dynamic job descriptorentry (DJDE) under this condition, unpredictable results mayoccur.• SPLIT = OFFSegment management processing is turned off when the LPSencounters a SPLIT=OFF dynamic job descriptor entry (DJDE).In addition, all segment management parameters are affectedin the following ways:— SRECOVER defaults to PAGE recovery— SEPARATORS are forced to NONE.— Segment numbering restarts to PART 001 if segmentmanagement processing is turned back on.You must use the DJDE SPLIT = (min, max) to reinstatesegment management processing after it has been disabled bythe DJDE SPLIT=OFF.• SPLIT = NOWIf segment processing is not in effect (that is, it either was notspecified in the JDL or the DJDE SPLIT=OFF was invoked), thesystem ignores the DJDE SPLIT=NOW.• Ending a segmentA segment may be ended under any of these conditions:— The maximum allowable value is reached. This value istaken from the specified value in the SPLIT command.— The end-of-report condition is met, including the logicalend-of-report as specified in the RSTACK command.— An end-of-data condition is met.— SEPARATORS is specified in a DJDE.— The system encounters a SPLIT=NOW dynamic jobdescriptor entry.— The system encounters a SPLIT=OFF dynamic jobdescriptor entry.• Using a new separator pageYou may use a new separator page under these conditions:— A SEPARATORS dynamic job descriptor entry (DJDE) isspecified.— An end-of-report condition is met, including the logical end-of-report as specified in the RSTACK command.
