PRINT FORMAT COMMANDS6-78 XEROX DOCUPRINT 180 LPS PDL REFERENCESHIFTImage shift is the shifting of the image data (system page) relative tothe physical page. This shifting is in the scan counting direction(vertical for landscape and horizontal for portrait). The SHIFTparameter specifies whether the image of the form and data on apage is to be shifted, and if so, by what values. This parameter isused to shift the image of the data in the y-direction for three-holepaper, binding, finishing, and edgemarking.Syntax OUTPUT SHIFT =option(s)Options Table 6-62 lists the parameter option(s) and definition(s).If the origin of a print line falls off the page, the entire line of data failsto print. This is especially important for duplex portrait-orientedpages, where a miscalculated shift could result in the entire pagefailing to print. When duplex shift is used, the left margin must be atleast .25 inches (75 dots) wide. When using the SHIFT parameter,make sure that the data is not shifted past the margin and off thepage.Refer to the "Points to note" section of the VOLUME command in thechapter "Specifying input parameters."Table 6-63. SHIFT parameter option(s) and definition(s)Option(s) Definition(s)v 1 An integer value in dots for the amount of shift on thesimplex page or the odd (front) side of the duplexpage. (Each dot is 1/300 of an inch.) Range for v1 is-75 to 75.v 2 A value in dots for the amount of shift on the even(back) side of a duplex page. Range for v2 is -75 to75. A standard size shift occurs if YES is specified(v1=75 and v2=-75).YES Specifies that a shift occurs. A standard size shiftoccurs if YES is specified (v1=75 and v2 =-75).NO Specifies that no shift occurs (v1=0 and v2=0).The default is NO.
