SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)8-64 XEROX DOCUPRINT 180 LPS PDL REFERENCESPLITThis parameter specifies the use of segment management. Whensegment management is in effect, an end of segment conditionoccurs whenever max sheets (including separators) are generated oran end-of-copy or end-of-report condition occurs.Syntax SPLIT =option(s)Options Table 8-53 lists the parameter option(s) and definition(s).Considerations When SPLIT=OFF is specified, the segment number (nnn of part nnnon separator sheets) is reset from its current value and begins at 001again when segment management is turned on again.Table 8-57. SPLIT parameter option(s) and definition(s)Option(s) Definition(s)NOW Specifies that the current or upcoming end-of-page(backside if duplex) will mark the last data page of thesegment.(min,max) Specifies the minimum and maximum numbers ofsheets allowed in a segment. The minimum numberof sheets allowed is 2 and the maximum is 65,535.If a segment end has not occurred by the time maxsheets are generated, then the printer declares end-of-segment. If end-of-segment occurs before minsheets are generated, then the printer generatespadding of either blank or multiple LAST sheets (ifthe LAST option of the SEPARATORS parameterhas been specified). If specified with segmentmanagement already in effect, then the currentsegment is tested against the new max and if greater,an end-of-segment is immediately declared.OFF Specifies that printer segment management not beprovided, and if currently in effect, be immediatelyterminated.
