SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)XEROX DOCUPRINT 180 LPS PDL REFERENCE 8-55PMODEThis parameter specifies the printing mode for each page.LANDSCAPE indicates that printing is to be parallel to the long edgeof paper. PORTRAIT indicates that printing is to be parallel to thenarrow edge of paper. If PMODE is changed through a DJDEcommand, the BEGIN command should be respecified (even if thesame horizontal and vertical position has been specified in theprevious BEGIN parameter).Syntax PMODE =option(s)Options Table 8-42 lists the parameter option(s) and definition(s).RFORMThis parameter specifies a form to be printed with all RTEXT pages.It takes effect on the next RTEXT page. The parameters are thesame as for the ROUTE command defined in the chapter "Printformat commands."Syntax RFORM =option(s)Options Table 8-43 lists the parameter option(s) and definition(s).Table 8-46. PMODE parameter option(s) and definition(s)Option(s) Definition(s)LANDSCAPE Indicates that printing is to be parallel to the longedge of paper.PORTRAIT Indicates that printing is to be parallel to the narrowedge of paper.Table 8-47. RFORM parameter option(s) and definition(s)Option(s) Definition(s)form-id This is the name of a file cataloged in the FRMdirectory. It is created by compiling a file of formssource commands, called a JSL, with the FDLcompiler. (Refer to the DocuPrint 180 LPS FormsCreation Guide.) The RFORM parameter is notallowed in a ROUTE command which is beingdefined as a cataloged file but is specified in theROUTE command in the JSL invoking thecataloged RTEXT file. Refer to the “CatalogedRTEXT files” section in this chapter for furtherdetails.NONE Specifies that no form is to be printed.The default is NONE.
