PRINT FORMAT COMMANDSXEROX DOCUPRINT 180 LPS PDL REFERENCE 6-45BTEXTThis parameter supports the PC UI report audit logging feature whichcreates an audit log on the UI hard disk. The audit log is initiated andterminated by including enabling data in the job stream. The PDL/DJDE command, BTEXT, is implemented primarily to supportbarcode audit logging which is not implemented in the DocuPrint180 LPS. BTEXT report definition parameters are, however, usefulwithout the installation of a barcode reader. Page definitionparameters, on the other hand, are meaningless without barcode textor a barcode reader.Note: DocuPrint 180 LPS does not support the barcode option.Barcode commands which are encountered by the DocuPrint 180LPS controller will be gracefully ignored (no syntax errors will benoted, no messages or operator information pages will begenerated).Syntax MESSAGE BTEXT =option(s)Options Table 6-39 lists the parameter option(s) and definition(s).Table 6-36. BTEXT parameter option(s) and definition(s)Option(s) Definition(s)RNA=xxx Report name (maximum of 16 characters). Thiskeyword is required in the first BTEXT of each reportto be audited. It may only occur once per report. Forclarity in relating the audit reports to SFS reports, thisshould be the same value used for job accounting.This parameter must be present to audit a job orreport.CJN=sss Customer job number (maximum of 6 digits). Forclarity in relating the audit report to SFS reports, thisshould be the same value used for job accountingDPT=xxx Department name (maximum of 31 characters). Forclarity in relating the audit reports to SFS reports, thisshould be the same value used for job accounting.
