115Configure Remote Authentication for SMBAt Your Workstation:1. With the Authentication Configuration web page still running, click Configure next to the server youwish to use for Authentication. If not still running, perform steps 2 and 3 below.2. If the web page is not still running, open your Web browser and enter the TCP/IP address of themachine in the Address or Location field. Press Enter.3. Click the Properties tab and return to the Security folder.4. Select the Remote Authentication Server / Directory Service folder in the list of hot links, selectAuthentication System and pick SMB from the drop-down list. Click Apply.5. Select SMB Server Settings.6. From the SMB Server Setup drop-down menu, select your desired method. The selections include:By Domain Name, and By Domain Name and Server Address / IP Address.7. Enter the Domain name (up to 15 characters) in the SMB Server – Domain Name box, for everyDomain Controller specified. This entry is required regardless of the selection made from the SMBServer Setup drop-down menu.8. Enter the IP Address of the Domain Controller in the SMB Server – Server Name / IP Address box (ifBy Domain Name and Server Address / IP Address was selected for SMB Server Setup).9. Enter the IP Addresses of up to 4 additional Backup Domain Controllers, if applicable.10. If you choose not to enter IP addresses, enter the Server Name (up to 64 characters) in the SMBServer – Server Name / IP Address box (if By Domain Name and Server Address / IP Address wasselected for SMB Server Setup).11. Click Apply, and supply the Administrator User name and password if prompted.