2Some Network Environment settings can only be configured through use of Internet Services. Also,nearly all of the services, ports, and protocols that can be configured at the Device can beconfigured with Internet Services running on a networked workstation. If Internet Services is shown as"disabled" on the Configuration Report, refer to the Enable Internet Services (HTTP) topic in this guide.If you will be using SNMP Management software with this device, refer to the SNMP Configuration topicand follow the instructions supplied.If you will be using the Parallel Port and wish to view or change its configuration, refer to the Parallel PortConfiguration topic and follow the instructions supplied.Step 5. Go to the NOS Selection section of this guide, then select your Network Operating System forDevice installation instructions specific to your network environment. If you will be installing the Device ina Client/Server environment, make sure to have your Server's Operating System Manual available to referto when required.Step 6. Go to the Print Drivers section of this guide for the instructions required to set up individualdesktop workstations to communicate with the Device.Step 7. If you have purchased optional features for your Device, such as Scanning to the Device's HardDrive, go to the Options section of this guide for configuration instructions.Note: For comprehensive information on the use of Internet Services as a browser-based, workstationtool for configuring your Device, go to the Internet Services section of this guide and click on relevanttopics from the menu list.Xerox Unicode 3.0 for SAP Font KitA Unicode font kit is available for this multifunction device. Installation of the Unicode fonts, per the kit’sinstructions, provides the required character sets to print documents in multiple languages, in an SAPprinting environment. To order the kit, contact your Xerox representative.Configuration ReportTo print a Configuration Report, with the Device switched ON, perform the following steps:1. Press the Machine Status button.2. Press the Print Reports button.3. Press the Copy Reports button.4. Press the Configuration Report button.5. Press the large, green, Start button, located to the immediate right of the Control Panel’s numerickeypad.6. The printing process will be graphically displayed on the touch screen. Upon receipt of theConfiguration Report, note that the multi-page print is formatted into two columns with horizontal ruledlines indicating four distinct data display areas on the print.• The first area displays System Settings.• The second area displays Copy Service Settings.• The third area displays Print Service Settings.• The fourth area displays Communication Settings.
