172Configuring SNMP Community Names with Internet Services1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.Press Enter.2. Click the Properties tab.3. Click the plus symbol (+) to the left of Connectivity, then the Protocols file folder.4. Select SNMP Configuration in the directory tree, and check the Enable box for the version desired.5. Enter a name for Community Name (Read Only), also known as GET.6. Enter a name for Community Name (Read/Write), also known as SET.Caution: If you change the GET and/or SET Community Names, you must also change the names inall network applications that are communicating by SNMP with this Device.7. Enter a name for the Community Name (Trap Notification). This is the default password for SNMPTRAPS sent from the device to the Manager by SNMP.8. Optionally enter the System Administrator's name for packet identification purposes.9. Select a trap and click Edit in the Trap Notification Settings section.10. Select your transport method (IPX or UDP) and fill in the trap destination information for your selectedmethod.11. Select the event(s) that you wish to report on by checking the applicable box(es).12. Click the Apply button to accept the changes, or the Undo button to return the settings to theirprevious values.Note: Changes to settings will not be applied until you restart the Device. A Reboot Machine button isavailable on the Status Tab of Internet Services.Configure Microsoft Networking (also known as SMB)For full instructions on configuring this device for Microsoft Networking, refer to the Microsoft (NetBIOSover IP) Networks topic in the NOS Selection section of this guide.
