11Exiting the Port Settings Menu and returning to the Device's Tools tab screen6. To exit the Port Settings menu, returning to the Tools tab screen, press the rectangular Close button inthe upper right corner of the Port Settings menu screen.7. Wait several seconds and the Auto Clear service should log you out.Note: If you changed any settings in the Port Settings menu, the Device will automatically reboot toregister and enable your new settings.Configuring SNMP Community Names with Internet Services1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.Press Enter.2. Click the Properties Tab.3. Click the plus symbol (+) to the left of the Connectivity, then the Protocols file folder.4. Select SNMP Configuration in the directory tree, and check the Enable box for the version desired.5. Click the Edit Properties button and supply the User Name (default of 11111) and Password (defaultof x-admin), if prompted.6. Enter a name for the Community Name (Read-Only). This is the password for SNMP GET requestsfrom the SNMP Manager to the Agent in the Device.7. Enter a name for the Community Name (Read-Write). This is the password for SNMP SET requestsfrom the SNMP Manager to the Agent in the Device.Caution: If you change the GET and/or SET Community Names, you must also change the names inall network applications that are communicating by SNMP with this Device.8. Enter a name for the Community Name (Trap Notification). This is the default password for SNMPTRAPS sent from the device to the Manager by SNMP.9. Optionally enter the System Administrator's name for packet identification purposes.10. Select a trap and click Edit in the Trap Notification Settings section.11. Select your transport method (IPX or UDP) and fill in the trap destination information for your selectedmethod.12. Select the event(s) that you wish to report on by checking the applicable box(es).13. Click Apply to accept the changes, or Undo to return the settings to their previous values.Note: Changes to settings will not be applied until you restart the Device.
