122Configure Remote Authentication for SMBAt Your Workstation:1. With the Authentication Configuration web page still running, click Configure next to the server youwish to use for Authentication. If not still running, perform steps 2 and 3 below.2. If the web page is not still running, open your Web browser and enter the TCP/IP address of themachine in the Address or Location field. Press Enter.3. Select the [Properties] tab. Note that (as of February 2007) you can either return to the Securityfolder and the Authentication Configuration hot link (discussed on the previous page), or use thealternative path, stated below.4. Select the Remote Authentication Server / Directory Service folder in the list of hot links, selectAuthentication System and pick SMB from the drop-down list. Click Apply.5. Select SMB Server Settings.6. From the SMB Server Setup drop-down menu, select your desired method. The selections include:By Domain Name, and By Domain Name and Server Address / IP Address.7. Enter the Domain name (up to 15 characters) in the SMB Server – Domain Name box, for everyDomain Controller specified. This entry is required regardless of the selection made from the SMBServer Setup drop-down menu.8. Enter the IP Address of the Domain Controller in the SMB Server – Server Name / IP Address box (ifBy Domain Name and Server Address / IP Address was selected for SMB Server Setup).9. Enter the IP Addresses of up to 4 additional Backup Domain Controllers, if applicable.10. If you choose not to enter IP addresses, enter the Server Name (up to 64 characters) in the SMBServer – Server Name / IP Address box (if By Domain Name and Server Address / IP Address wasselected for SMB Server Setup).11. Click Apply, and supply the Administrator User name and password if prompted.Configure Remote Authentication for LDAPRefer to your LDAP server documentation for the full range of information that can be entered into thisLDAP dialog to fully support both E-mail applications and authentication using your LDAP server.The path to the LDAP dialog is as follows:At Your Workstation:1. With the Authentication Configuration web page still running, click Configure next to the server youwish to use for Authentication. If not still running, perform steps 2 and 3 below.2. If the web page is not still running, open your Web browser and enter the TCP/IP address of themachine in the Address or Location field. Press Enter.3. Click the Properties tab. Note that (as of February 2007) you can either return to the Security folderand the Authentication Configuration hot link (discussed on the previous page), or use the alternativepath, stated below.4. Select the Remote Authentication Server / Directory Service folder in the list of hot links, selectAuthentication System and pick LDAP from the drop-down list. Click Apply.5. Select LDAP Server / Directory Service.6. Enter the Primary Server IP address (or host name) in the box supplied. Note: If entering a fullyqualified host name (for example, ldapserver.xerox.com), make sure that the specified domain namematches the device’s TCP/IP configuration (domain name shown under DNS on the device’sConfiguration Report).7. Enter the Primary Server Port Number (default of 389).
