YASKAWA SI-EP3 Technical Manual

Also see for SI-EP3: Technical manual Technical manual Installation manual Installation manual

4 Option Components10 YASKAWA SIEP C730600 89E PROFINET Technical ManualTable 4.1 Male 8-way Ethernet Modular Connector (Customer-Supplied)Male EtherNet 8-Way Modular Connector Pin Description1 (Pair 2) Transmit data (TXD) +2 (Pair 2) Transmit data (TXD) -3 (Pair 3) Receive data (RXD) +4 (Pair 1) Not used *15 (Pair 1) Not used *16 (Pair 3) Receive data (RXD) -7 (Pair 4) Not used *18 (Pair 4) Not used *1*1 Not used for 10 Mbps and 100 Mbps networks.◆ Option LED StatesThe option has four LEDs:• Bi-color Status LEDs:– Module status (MS) red/green– Network status (NS) red/green• Ethernet LEDs (2 each):– Network speed-10/100 yellow– Link status and network activity-Link/Act greenA - 1000-SeriesB - GA500, GA700, GA800, CR700, and CH700C - HV600 *1Figure 4.2 Option LED Labels*1 LED label has transparent background and white letters. Please make sure that you use the correct label for HV600.Wait 2 seconds minimum for the power-up diagnostic process to complete before you verify the LED states. Theoperational status of the option LEDs after the power-up diagnostic LED sequence is complete are described inTable 4.2. The statuses with a number in parenthesis are the number of pulses of 250 ms ON and 250 ms OFF.When pulses of ON and OFF are completed for the number of times, LED will be 500 ms OFF, then repeat thecycle of ON and OFF for the number of times.Refer to Table 4.3 for more information about the LEDs.Table 4.2 Option LED StatesLED NameIndicationOperating Status DescriptionColor StatusMS (visible through drive cover)- OFF Power supply off There is no power to the drive.Green ON Option operating The option is operating normally andinitialization is complete.Green Flashing (1) Diagnostics Diagnostic data available.Green Flashing (2) Configuration tool Identified by a configuration tool.Red ON Default MAC or fatal error occurred.The default MAC address is programmedor the option detected an unrecoverableerror.Red Flashing (1) Invalid Station Name programmed The device has an invalid Station name.You must use a valid station name from thePLC software or web page and rewrite it.Red Flashing (2) No IP (non-fatal) No IP address assigned.Red Flashing (3) No station name (non-fatal) No station name assigned.