4 Option ComponentsYASKAWA SIEP C730600 89E PROFINET Technical Manual 9Option Contents QuantityHV600 *3 1Installation Manual 1*1 GA700, GA800, CR700, and CH700 drives do not use the ground wire.*2 GA700, GA800, CR700, CH700, and HV600 drives use two screws only.*3 LED label has transparent background and white letters. Please make sure that you use the correct label for HV600.◆ Installation ToolsYou can use these tools to install the option to the drive:• A Phillips screwdriver or slotted screwdriver (blade depth: 0.4 mm (0.02 in), width: 2.5 mm (0.1 in)) *1.• A pair of diagonal cutting pliers.• A small file or medium-grit sandpaper.*1 Phillips screw sizes are different for different drive capacities. Prepare different screwdrivers for differentscrew sizes.4 Option Components◆ OptionA - Connector (CN5)B - Installation holeC - LED (NS) *1D - LED (MS) *1E - PROFINET PCBF - Software number labelG - Ground terminal (FE) and installation hole *2H - Port 1 LED (10/100) *1I - Port 1 (RJ45)J - Port 1 LED (LINK/ACT) *1K - Port 2 LED (10/100) *1L - Port 2 (RJ45)M - Port 2 LED (LINK/ACT) *1N - PROFINET cable connectionFigure 4.1 Option*1 Refer to Option LED States on page 10 for more information about the LEDs.*2 Connect the included ground wire during installation. The ground wire is not necessary for installations on GA700, GA800, CR700,and CH700 drives.◆ Communication Modular Connector CN1 Port 1/Port 2The communication modular connector CN1 on the option is a modular dual RJ45 female connector designatedport 1 and port 2. Port 1 and port 2 are the connection points for a customer-supplied male Ethernet networkcommunication cable.