6 Related Drive ParametersYASKAWA SIEP C730600 89E PROFINET Technical Manual 25*3 On an HV600 drive, install the option to the drive, connect one end of the included ground wire to the ground terminal on the drive,then connect the other end of the ground wire to the the ground terminal and installation hole on the option.■ Prepare and Connect Communication Cable WiringThe option modular connector CN1 port 1 and port 2 act as a switch to allow for flexibility in cabling topology.Users may employ a traditional star network topology using either CN1 port 1 or CN1 port 2 on the option. Usersmay also choose to employ a ring topology using both CN1 port 1 and CN1 port 2 on the option and reduce therequirements of PROFINET switch ports.A - PLCB - PROFINET switchC - DriveFigure 5.23 Prepare and Connect Communication Cable Wiring◆ GSD FilesTo facilitate network implementation, obtain a GSD file from one of the following websites depending on yourregion: U.S.: http://www.yaskawa.com Europe: http://www.yaskawa.eu.com Japan: http://www.e-mechatronics.com Other areas: Check the back cover of these manuals. For questions, contact Yaskawa or a Yaskawarepresentative.Note:Download the GSD file for YASKAWA AC Drive Option SI-EP3. If you download an incorrect GSD file, this product will not operateas a slave in the network.6 Related Drive ParametersThese parameters set the drive for operation with the option. Confirm correct parameter settings in this tablebefore you start network communications.Note:Hex.: MEMOBUS addresses that you can use to change parameters over network communication are represented in hexadecimalnumbers.