5 Installation Procedure16 YASKAWA SIEP C730600 89E PROFINET Technical Manual7. Use both CN1 port 1 and CN1 port 2 at the same time to daisy chain a series of drives where applicable.8. Reattach the front cover (A), terminal cover (C), and keypad (B).Refer to the drive manuals for more information.NOTICE Do not pinch cables between the front covers and the drive. Failure to comply could causeerroneous operation.A - Drive front coverB - KeypadC - Drive terminal coverFigure 5.7 Replace the Front Cover, Terminal Cover, and Keypad9. Set drive parameters in Related Drive Parameters on page 25 for correct option performance.■ Procedure BThis section shows the procedure to install and wire the option on a GA700, GA800, CR700, or CH700 drive.Prepare the Drive for the OptionBefore you install the option on a YASKAWA AC Drive GA700, GA800, CR700, or CH700, make sure that theoption software version is PRG: 4400 or later.Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functionscorrectly. For information about drive connection and wiring, refer to the manuals for the drive on which you willuse this option.