YASKAWA SI-EP3 Technical Manual

Also see for SI-EP3: Technical manual Technical manual Installation manual Installation manual

5 Installation Procedure12 YASKAWA SIEP C730600 89E PROFINET Technical ManualWARNING Electrical Shock Hazard. Do not use damaged wires, put too much force on the wiring, or cause damage tothe wire insulation. Damaged wires can cause serious injury or death.WARNING Fire Hazard. Tighten all terminal screws to the correct tightening torque. Connections that are too loose or tootight can cause incorrect operation and damage to the drive. Incorrect connections can also cause death or serious injury fromfire.NOTICE Damage to Equipment. Observe correct electrostatic discharge (ESD) procedures when touching the option.Failure to obey can cause ESD damage to the option circuitry.NOTICE Damage to Equipment. Do not de-energize the drive while the drive is outputting voltage. Incorrect equipmentsequencing can cause damage to the drive.NOTICE Do not operate a drive or connected equipment that has damaged or missing parts. You can cause damage tothe drive and connected equipment.NOTICE Use Yaskawa connection cables or recommended cables only. Incorrect cables can cause the drive or optionto function incorrectly.NOTICE Damage to Equipment. Correctly connect the connectors. Incorrect connections can cause malfunction ordamage to the equipment.NOTICE Damage to Equipment. Make sure that all connections are correct after you install the drive and connectingperipheral devices. Incorrect connections can cause damage to the option.◆ Procedures for Installing and Wiring Options on a DriveProcedures to install and wire the option are different for different drivel models.Refer to the following table to check the procedures to install and wire the option on a drive.Table 5.1 Procedures for Installing and Wiring Options on a DriveProduct Series Procedures to Install and Wire Options on a Drive PageA1000 Procedure A 12U1000 Procedure A 12U1000L Procedure A 12Z1000U Procedure A 12GA500 *1 *2 -GA700 Procedure B 16GA800 Procedure B 16CR700 Procedure B 16CH700 Procedure B 16HV600 Procedure C 20*1 To install the option on GA500 drives, use the option mounting kit and manual.*2 Before you install the option on a YASKAWA AC Drive GA500, make sure that the option software version is PRG: 4400 or later.■ Procedure AThis section shows the procedure to install and wire the option on a 1000-series drive.Prepare the Drive for the OptionCorrectly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functionscorrectly. For information about drive connection and wiring, refer to the manuals for the drive on which you willuse this option.