YASKAWA SI-EP3 Technical Manual
Also see for SI-EP3: Technical manualTechnical manualInstallation manualInstallation manual
                                                        | |
Contents
|
5 Installation Procedure22 YASKAWA SIEP C730600 89E PROFINET Technical Manual3. Remove the screw (B) installed in the drive grounding terminal (A).A - Drive grounding terminal (FE) B - Ground screwFigure 5.17 Remove the Screw of the Drive Grounding Terminal4. Use the screw (B) installed in the FE ground terminal of the drive (A) to connect one end of the includedground wire (C) to the ground terminal on the drive.Tighten the screw to a correct tightening torque:• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)Note:Route ground wire through the right side of the stud (D).A - Drive grounding terminal (FE)B - Ground screwC - Ground wireD - StudFigure 5.18 Connect the Ground Wire5. Install the option (A) into the CN5 connector (C) on the drive and use one of the included screws (B) to putit in place.Tighten the screw to a correct tightening torque:• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb) |
Related manuals for YASKAWA SI-EP3
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine