B.6 E: Motor Parametersu E1: V/f Pattern for Motor 1No.(Addr.Hex) Name Description Values PageE1-01(300)Input Voltage SettingInput VoltageThis parameter must be set to the power supply voltage.WARNING! Electrical Shock Hazard. Drive input voltage (not motorvoltage) must be set in E1-01 for the protective features of the drive tofunction properly. Failure to do so may result in equipment damageand/or death or personal injury.Default: 230 V <1>Min.: 190Max.: 240 <1>145E1-03(302)V/f Pattern SelectionV/F Selection0: 50 Hz, Constant torque 1 0: 50 Hz1: 60 Hz, Constant torque 2 1: 60 Hz Saturation2: 50 Hz, Constant torque 3 (50 Hz base) 2: 50 Hz Saturation3: 72 Hz, Constant torque 4 (60 Hz base) 3: 72 Hz4: 50 Hz, Variable torque 1 4: 50 Hz VT15: 50 Hz, Variable torque 2 5: 50 Hz VT26: 60 Hz, Variable torque 3 6: 60 Hz VT17: 60 Hz, Variable torque 4 7: 60 Hz VT28: 50 Hz, High starting torque 1 8: 50 Hz HST19: 50 Hz, High starting torque 2 9: 50 Hz HST2A: 60 Hz, High starting torque 3 A: 60 Hz HST1B: 60 Hz, High starting torque 4 B: 60 Hz HST2C: 90 Hz (60 Hz base) C: 90 HzD: 120 Hz (60 Hz base) D: 120 HzE: 180 Hz (60 Hz base) E: 180 HzF: Custom V/f F: Custom V/F` E1-05 setting defines the V/f patternDefault: F <2>Range: 0 to 9;A to F145E1-05(304)Maximum VoltageMax VoltageOnly applicable when E1-03 is set to F. Default: <3>Min.: 0.0 VMax.: 255.0 V <1>148<1> Values shown are specific to 208 Vac. Double the value for 480 Vac.<2> Parameter setting value is not reset to the default value when the drive is initialized.<3> Default setting is dependent on parameter o2-04, Drive Model Selection.u E2: Motor ParametersNo.(Addr.Hex) Name Description Values PageE2-01(030E)Motor Rated CurrentMotor Rated FLASets the motor nameplate full load current in amps. Automatically set duringAuto-Tuning. Default: <1>Min.: 10% of driverated currentMax.: 200% ofdrive rated current<2>149E2-03(310)Motor No-Load CurrentNo-Load CurrentSets the no-load current for the motor. Automatically set during Auto-Tuning. Default: <1>Min.: 0 AMax.: E2-01 <2>149<1> Default setting is dependent on parameter o2-04, Drive Model Selection.<2> The number of decimal places in the parameter value depends on the drive model. Refer to Defaults by Drive Model on page 356 for details.B.6 E: Motor ParametersYASKAWA ELECTRIC SIEP YAIZ1B 01E YASKAWA AC Drive – Z1000 Bypass Technical Manual 321B Parameter List
