D.2 European StandardsFigure D.1 CE MarkThe CE mark indicates compliance with European safety and environmental regulations. It is required for engaging in businessand commerce in Europe.European standards include the Machinery Directive for machine manufacturers, the Low Voltage Directive for electronicsmanufacturers, and the EMC guidelines for controlling noise.This drive displays the CE mark based on the EMC guidelines and the Low Voltage Directive.• Low Voltage Directive: 2006/95/EC• EMC Guidelines: 2004/108/ECDevices used in combination with this drive must also be CE certified and display the CE mark. When using drives displayingthe CE mark in combination with other devices, it is ultimately the responsibility of the user to ensure compliance with CEstandards. After setting up the device, verify that conditions meet European standards.u CE Low Voltage Directive ComplianceThis drive has been tested according to European standard IEC/EN 61800-5-1:2007, and it fully complies with the Low VoltageDirective.To comply with the Low Voltage Directive, be sure to meet the following conditions when combining this drive with otherdevices:n Area of UseDo not use drives in areas with pollution higher than degree 2 and overvoltage category 3 in accordance with IEC/EN 664.n Installing Fuses on the Input SideAlways install input fuses. Select fuses according to the table below.WARNING! Fire Hazard. Install adequate branch circuit protection according to applicable local codes and this manual. Failure to complycould result in fire and damage to the drive or injury to personnel. The device is suitable for use on a circuit capable of delivering not morethan 100,000 RMS symmetrical amperes, 240 Vac (200 V class) and 480 Vac (400 V class), when protected by branch circuit protectiondevices specified in this manual.Branch circuit protection shall be provided by any of the following: Non-time delay Class J, T, or CC fuses sized at 300% of the drive inputrating, or Time delay Class J, T, or CC fuses sized at 175% of the drive input rating, or MCCB sized at 200% maximum of the drive inputrating.Table D.1 Recommended Input Fuse SelectionModel Manufacturer: BussmannModel Fuse Ampere Rating (A)Three-Phase 200 V Class2A0011 FWH-40B 402A0017 FWH-50B 502A0024 FWH-80B 802A0031 FWH-100B 1002A0046 FWH-150B 1502A0059 FWH-175B 1752A0075 FWH-225A 2252A0088 FWH-225A 2252A0114 FWH-250A 2502A0143 FWH-275A 2752A0169 FWH-350A 3502A0211 FWH-400A 4002A0273 FWH-450A 450D.2 European Standards366 YASKAWA ELECTRIC TOEP C710616 45F YASKAWA AC Drive – Z1000 User Manual
