CONTROL SYSTEMCHKADJ3-9E(3) Make sure that the magnet base stop-per is in contact with the stopper onthe engine body (full-close end stop-per) .(4) Make sure that the lever is in contactwith the carburetor throttle stop screw.(5) Correct adjustment has been estab-lished if the cam roller is not in contactwith the accelerator cam.(6) If the lever is not in contact with thethrottle stop screw move the plate camto the left so that the lever comes tocontact with the throttle stop screw.NOTE:• When shifting the plate cam slightly, donot shift it more than 2 mm (0.079 in) tothe left from the point at which themarking line of the full-open mark "C"aligns with the centerline of the rollercam at full-throttle.• After adjustment, open and close thethrottle for several times, and reassurethat the lever is in contact with thethrottle stop screw on the carburetor,and that the cam roller is not in contactwith the accelerator cam.3434
