Configuring IPv6 BGP Basic Functions 1019router may fail to establish TCP connections to the peers when using theoutbound interfaces of the best routes as the source interfaces.Configuring a Non DirectEBGP Connection to aPeer/Peer GroupFollow these steps to configure an EBGP connection to a peer not directlyconnected:c CAUTION: In general, direct links should be available between EBGP peers. If not,you can use the peer ebgp-max-hop command to establish a multi-hop TCPconnection in between. However, you need not use this command for direct EBGPconnection with loopback interfaces.Configuring Descriptionfor a Peer/Peer GroupFollow these steps to configure description for a peer/peer group:n The peer group for which to configure description must have been created.Establishing No Sessionto a Peer/Peer GroupFollow these steps to disable session establishment to a peer/peer group:Logging Session Stateand Event Informationof a Peer/Peer GroupFollow these steps to log on the session and event information of a peer/peergroup:To do... Use the command... RemarksEnter system view system-view -Enter BGP view bgp as-number RequiredEnter IPv6 address family view ipv6-family -Configure a non direct EBGPconnection to a peer/peergrouppeer { ipv6-group-name |ipv6-address } ebgp-max-hop[ hop-count ]RequiredNot configured bydefaultTo do... Use the command... RemarksEnter system view system-view -Enter BGP view bgp as-number RequiredEnter IPv6 address family view ipv6-family -Configure description for apeer/peer grouppeer { ipv6-group-name |ipv6-address } descriptiondescription-textOptionalNot configured by defaultTo do... Use the command... RemarksEnter system view system-view -Enter BGP view bgp as-number RequiredEnter IPv6 address family view ipv6-family -Disable session establishmentto a peer/peer grouppeer { ipv6-group-name |ipv6-address } ignoreOptionalNot disabled by defaultTo do... Use the command... RemarksEnter system view system-view -Enter BGP view bgp as-number Required
