Displaying and Maintaining Link Aggregation 353Entering AggregationPort Group ViewIn aggregation port group view, you can make configuration for all the memberports in a link aggregation group at one time.Follow these steps to enter aggregation port group view:c CAUTION: In aggregation port group view, you can configure aggregation relatedsettings such as STP, VLAN, QoS, GVRP, MAC address learning, but cannot add orremove member ports.Displaying andMaintaining LinkAggregationLink AggregationConfigurationExampleNetwork requirementsDevice A aggregates ports Ethernet 1/1 through Ethernet 1/3 to form one linkconnected to Device B and performs load sharing among these ports.Create an IPv6 service-loop group and assign port Ethernet 1/1 to the group.To do... Use the command... RemarksEnter system view system-view --Assign a name for anaggregation grouplink-aggregation groupagg-id description agg-nameRequiredNone is configured by default.To do... Use the command... RemarksEnter system view system-view --Enter aggregation port groupviewport-group aggregation agg-id --To do... Use the command... RemarksDisplay the local system ID display lacp system-id Available in anyviewDisplay detailed informationabout link aggregation forthe specified port or portsdisplay link-aggregation interfaceinterface-type interface-number [ tointerface-type interface-number ]Available in anyviewDisplay summaries for all linkaggregation groupsdisplay link-aggregation summary Available in anyviewDisplay detailed informationabout specified or all linkaggregation groupsdisplay link-aggregation verbose[ agg-id ]Available in anyviewClear the statistics aboutLACP for specified or all portsreset lacp statistics [ interfaceinterface-type interface-number [ tointerface-type interface-number ] ]Available in userview
