2016 CHAPTER 109: NQA OVERVIEWNQA Test Operation After you create a test group and enter the test group view, you can configurerelated test parameters. Test parameters vary with the test type. For details, see theconfiguration procedure below.To perform an NQA test successfully, perform the following configurations on theNQA client:1 Enable the NQA client;2 Create a test group and configure test parameters according to the test type;3 Perform the NQA test through the related enable commands;4 View test results using the display or debug commands.For TCP, UDP-jitter or UDP-echo tests, you need to configure the NQA server onthe peer device.NQA ConfigurationTask ListComplete these tasks to configure NQA.Configuring the NQAServerBefore performing TCP, UDP-echo or UDP-jitter tests, you need to configure theNQA server on the peer device. The NQA server makes a response to the requestsTask Remarks“Configuring the NQA Server” on page 2016 Required for TCP, UDP-echoand UDP-jitter tests“Enabling the NQA Client” on page 2017 Optional“Creating an NQA Test Group” on page 2017 Required“Configuring an NQA TestGroup” on page 2017“Configuring the ICMP-echoTest” on page 2017Use any of the approaches.“Configuring the DHCP Test”on page 2019“Configuring the FTP Test” onpage 2019“Configuring the HTTP Test”on page 2020“Configuring the UDP-jitterTest” on page 2021“Configuring the SNMP Test”on page 2023“Configuring the TCP Test”on page 2024“Configuring the UDP-echoTest” on page 2025“Configuring the DLSw Test”on page 2026“Configuring the Collaboration Function” on page 2027 Optional“Configuring Trap Delivery” on page 2027 Optional“Configuring Optional Parameters Common to an NQA TestGroup” on page 2028Optional“Scheduling an NQA Test Group” on page 2029 Required
