1638 CHAPTER 84: T RAFFIC CLASSIFICATION, POLICING, AND S HAPINGConfiguration example for Line Rate on physical interfaceConfigure outbound line rate on interface Ethernet1/0 to 500 kbps.# Enter system view. system-view# Enter interface view[Sysname] interface ethernet1/0# Configure line rate parameter, and configure the outbound cir to 500 kbps.[Sysname-Ethernet1/0] qos lr outbound cir 500Displaying andMaintainingTP/TS/Rate LimitingConfigure layer 2 interfacemodule LRqos lr { inbound|outbound } circommitted-information-rate[ cbs committed-burst-size[ ebs excess-burst-size ] ]RequiredFor a device which cannot beinstalled with an externalinterface module, or whenthe number of the interfaceson a layer 2 module is 4 or 9,inbound, cbs and ebs arenot supported; if the numberof interfaces on a layer 2module is 16, 24, or 48, ebsis not supported on themodule and cbs defaults to4096 bytes.Enter port group view port-group aggregationagg-id-Configure port group LR qos lr { inbound|outbound } circommitted-information-rate[ cbs committed-burst-size[ ebs excess-burst-size ] ]RequiredPort group is supported if thenumber of interfaces on alayer 2 module is 16, 24 or48.The default value is the sameas that of the layer 2 interfacemodule.Display LR configuration andstatistics on interfacedisplay qos lr interface[ interface-typeinterface-number ]The display command can beexecuted in any view.To do... Use the command... RemarksTo do... Command RemarksDisplay TP rules display qos carl [ carl-index ] Available inany viewDisplay TP information on an interface display qos car interface[ interface-type interface-number ]Display the TS information on ainterfacedisplay qos gts interface[ interface-type interface-number ]Display rate limiting configuration onan interface and the related statisticsinformationdisplay qos lr interface[ interface-type interface-number ]
