Configuring Voice RADIUS 2419n Pay attention to the following points when configuring the number of redialattempts■ For the card number/password process, the number of redial attempts appliesto each dial step, including selecting a language option, and dialing a cardnumber, password, or called number.■ The redialtimes command is used to configure the number of redial attempts.Therefore, the number of dial attempts is the number of redial attempts plus 1.For example, if the number of redial attempts is n (redialtimes-number = n),then the number of dial attempts is n + 1.Enabling LanguageSelection FunctionThe language selection function applies to only the caller number process withIVR. With the language selection function enabled, the voice gateway will playtones to prompt for a language first and then a called number after a user dials anaccess number.Configuration prerequisitesYou have configured an access number and entered access number view.Configuration procedureFollow these steps to configure the language options:Enter dial program view dial-program -Enter access number view gw-access-numberaccess-number-Specify the two-stage dialing processas card number/password process orcaller number process with IVRprocess-config cardnumber orprocess-config voice-callerRequiredConfigure the number of redialattemptsredialtimes redialtimes-number Required3 by default.To do... Use the command... RemarksTo do... Use the command... RemarksEnter system view system-view -Enter voice view voice-setup -Enter dial program view dial-program -Enter access number view gw-access-numberaccess-number-Specify the two-stage dialingprocess as caller numberprocess with IVRprocess-config voice-caller RequiredConfigure the languageoptionsselectlanguage { enable |chinese | english }RequiredChinese by default. After auser dials the access number,the voice gateway plays tonesin Chinese to prompt for acalled number.
