VoFR Configuration Example 2399# Configure the POTS entity (0101001).[RouterA-voice-dial-entity755] entity 1001 pots[RouterA-voice-dial-entity1001] match-template 0101001[RouterA-voice-dial-entity1001] line 3/02 Configure Router B.Router B is an industry-leading router and is configured according to the networkrequirements and network diagram.FRF.11 Trunk Network requirementsTelephone A (010-1001) attached to voice Router A in City A communicates withTelephone B (0755-2001) attached to voice Router B in City B over a frame relaynetwork.Telephone A (010-1001) in City A is attached to the FXS subscriber line of RouterA and can communicate with Telephone B (0755-2001) in City B through anFRF.11 trunk by dialing “9”. The PBX in City B is connected to Router B throughthe FXO subscriber line. Telephone B (0755-2001) in City B can communicate withTelephone A in City A through an FRF.11 trunk by dialing “8”.Network diagramFigure 696 Network diagram for FRF.11 trunk VoFRConfiguration procedure1 Configure Router A.# Create a new frame relay class “VoFR” and set the maximum amount of voicebandwidth. system-view[RouterA] fr class vofr[RouterA-fr-class-vofr] voice bandwidth 32000 reserved[RouterA-fr-class-vofr] quit# Enter Serial 2/0 view and configure the encapsulation format and interface type.[RouterA] interface serial 2/0[RouterA-Serial2/0] link-protocol fr ietf[RouterA-Serial2/0] fr interface-type dce# Enter DLCI 100 view and set the frame relay class to VoFR for DLCI.S2/0 S1/0Router A Router B010 -1001 0755 -2001City A City BPBXFrame Relay
