56Software Installation and User’s GuideInstalling Microsoft Windows NT / 2000 / XPNote: As of this writing, this software package had not passed Windows Logo testing forWindows XP. However, certification is anticipated in the very near future. As a result, awindow may appear notifying you about the Windows Logo testing compatibility. Youcan simply click on 'Continue Anyway' to complete your software installation.e. If the “New hardware found” wizard appears for the IOCTL device, select 'Installfrom a list or specific location', click Next, then select 'Search removable media'and click Next again to load the driver from the floppy disk.f. Click on Finish to complete your installation.7. Go to Section 10.2, Installing and Launching ICPCON to install the tools and utilitiesof the RAID Software Suite.4.1.6 Replacing Compatible ICP RAID Controllers in Windows 2000 /XPThe procedure for replacing an ICP RAID controller with another compatible but differentmodel is different depending on where the operating system is installed. SeeSection 4.1.6.1 if the operating system is installed on a host drive connected to the ICPRAID controller or Section 4.1.6.2 if the operating system is installed on an IDE driveconnected to the motherboard.For a list of compatible ICP RAID controllers, see the Hardware Guide.4.1.6.1 If OS Is on a Host Drive Connected to the ICP RAID ControllerIf Windows OS is installed to a host drive connected to the ICP RAID controller, thenreplacing an ICP RAID controller with another compatible but different model is similarto the procedure for adding a new controller. The important distinction is that you add thenew ICP RAID controller into the system first, before removing the old controller.Caution: If you do not install the new host adapter first, it may result in a Windows OS bootfailure.To swap compatible ICP RAID controllers, follow these steps:1. Power down your computer.2. Insert the new (compatible) ICP RAID controller into an available PCI slot, leavingthe existing ICP RAID controller intact.3. Power up your computer. Your Windows OS should load up as normal and detect thenew ICP RAID controller. Install the Windows OS driver if prompted to. If a driverinstall Wizard starts, follow the same driver installation procedures as in the User'sManual.4. Reboot if prompted.5. Once the new ICP RAID controller is functioning properly, power down yourcomputer.6. Remove the old ICP RAID controller (leave the new ICP RAID controller in the slotthat it was initially installed in and detected by your Windows OS) and move alldesired devices to the new adapter.
