76Software Installation and User’s GuideInstalling SCO UnixWareInstalling SCO UnixWare 7This section discusses installation issues related to the SCO UnixWare operating systems(UnixWare 7.1.1 and UnixWare 8.0). For a successful installation, study the SCO systemmanuals thoroughly. The required drivers can be created from the RAID Software SuiteCD-ROM.7.1 General Installation NotesThis section identifies the minimum hardware and software required to successfullyinstall the ICP RAID controller with the accompanying RAID Software Suite. Ensure thatyou have completed the steps described in Chapter 2, “Getting Started,” before beginningthe installation described in this chapter.7.1.1 Minimum Hardware RequirementsFor detailed hardware requirements, specifications, and installation procedures specific toyour ICP RAID controller, consult the Hardware Guide.7.1.1.1 Computer System Requirements• Computer with CD-ROM Drive (not attached to the ICP RAID controller)• One available PCI slot• ICP RAID controller• PCI 2.2 compliant system BIOS• SCSI hard disk drives (the minimum needed to meet desired RAID level requirements)Note: If the ICP RAID controller is configured with removable SDRAM, be sure that the DIMMis installed in the adapter prior to use. (Ensure that the optional battery backup isdisconnected during any installation or removal of the DIMM). Not all adapters areconfigured with removable SDRAM or battery backup support. For installation detailsand applicability to your ICP RAID controller, consult the Hardware Guide.7.1.2 Minimum Software Requirements• RAID Software Suite CD-ROM• 20 MB of free hard disk space• RAID Software Suite Driver Installation diskette for UnixWare (see Section 2.2, Createthe RAID Driver Installation Diskette for instructions).— One blank high density floppy diskette† may be required to create the installationdiskette• SCO UnixWare 7.1.1 or 8.0† OS software
