SNMP Community Names ScreenDLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s Guide 5-53read-write This community name allows read and writeaccess to the DLE2X-MA and DLE3X-MAMIB objects, excluding security protectedfields for super-user access only.super-user This community name permits read-writeaccess to the DLE2X-MA and DLE3X-MAMIB objects and allows the user to change allmodifiable parameters including communitynames, IP addresses, traps, and SNMP objects.5.16.1 Establishing Community NamesThe password used to access Local Management at the Password Screenmust have Super-User access in order to view and edit the SNMPCommunity Names screen. Using a password with read-only orread-write access does not allow the user to view or edit the SNMPCommunity Names screen.To establish community names, proceed as follows:1. Use the arrow keys to highlight the Community Name field adjacentto the selected access level.2. Enter the password in the field (maximum 31 characters).3. Press ENTER.4. Repeat steps 1 through 3 to modify the other community names.5. Use the arrow keys to highlight SAVE at the bottom of the screen andpress ENTER. The message “SAVED OK” displays. The communitynames are saved to memory and their access modes implemented.Any community name assigned in the SNMP CommunityNames screen is a password to its corresponding level ofaccess to Local/Remote Management. The community nameassigned Super-User access is the only one that gives the usercomplete access to Local/Remote Management.