Installing Optional Fast Ethernet Interface ModulesDLE22-MA, DLE32-MA, DLE23-MA and DLE33-MA User’s Guide C-5To install a Fast Ethernet Interface Module in port slot 25 or 26 of theDLE2X-MA, proceed as follows:1. Remove the coverplate from the port slot where the Fast EthernetInterface Module will be installed.To remove a coverplate, refer to Figure C-3 and proceed as follows:a. Remove the two screws fastening the coverplate to the standoffs.Save the screws.b. Lift and remove the coverplate from the top of the front standoffs.! The Fast Ethernet Interface Module and the host module aresensitive to static discharges. Use an antistatic wrist strap andobserve all static precautions during this procedure. Failure todo so could damage the Fast Ethernet Interface Module or thehost module.The DELF3-UI uses Class 1 lasers. Do not use opticalinstruments to view the laser output. The use of opticalinstruments to view laser output increases eye hazard. Whenviewing the output optical port, power must be removed fromthe network adapter.When installing Fast Ethernet Interface Modules in both portslots 25 and 26, remove the coverplates from both slotopenings. In the following instructions, the optional module isshown being installed in port slot 26.
