Chapter 5: Local Management5-62 DLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s GuideSET ALL PORTS (Toggle)Ports 1 through 24 can be set all at once to either STANDARD or FULLfrom this field. To set all ports, refer to Section 5.19.1.[1-12], or [13-24] (Navigation Key)When the Full Duplex Configuration screen displays, the currentoperation mode and status information are displayed for the first 12 ports.This field allows the user to step to a second screen for the same type ofinformation for ports 13 through 24. While on the second screen, the usercan navigate back to the first screen by selecting the [1-12] option. Theuser can change the Operation Mode fields while in either the first orsecond screen.5.19.1 Setting the Operation ModeThe Operation Mode may be set to Standard Ethernet or Full Duplexeither one port at a time or all at once. The following steps describesetting the port Operation Mode for individual ports followed by steps toset the Operation Mode for all ports.Set the Operation Mode for individual ports as follows:1. Use the arrow keys to highlight the OPERATION MODE fieldadjacent to the number of the port that you plan to change.2. Press the SPACE bar until the appropriate mode (FULL DUPLEX orSTANDARD ENET) is displayed.3. Use the arrow keys to highlight the SAVE command on the bottomline of the screen.4. Press ENTER. The message “SAVED OK” is displayed.To set all 24 Ethernet ports for Full Duplex or Standard Ethernet, proceedas follows:1. Use the arrow keys to highlight the SET ALL PORTS field.The Operation Mode for the first 12 ports can be changed onthe first screen. To display the Operation Mode for Ports 13through 24, use the arrow keys to highlight the Ports [13-24]field and press ENTER. To again display the Operation Modefor Ports 1 through 12, use the arrow keys to highlight the Ports[1-12] field and press ENTER.